Configuring a Load Balancing Mode

Run:
system-view
The system view is displayed.
Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Run:
load-balance { dst-ip | dst-mac | src-ip | src-mac | src-dst-ip | src-dst-mac }
The load balancing mode of the Eth-Trunk is set.

NOTE:
The S2350, S5328C-SI    and S5300LI use the parameter src-dst-ip in the HASH algorithm for load balance regardless of whether you configure this parameter.
On the S2350, S5300LI, and S5300SI, when the load balancing mode of an Eth-Trunk is modified, the modification takes effect on all Eth-Trunks. The load balancing mode will be set to the default mode when a new Eth-Trunk is created.

Run:
system-view
The system view is displayed.
Run:
load-balance-profile profile-name
A load balancing profile is created and its view is displayed. Only one load balancing profile can be created.
Run:
l2 field [ dmac | l2-protocol | smac | sport | vlan ] *
The load balancing mode of Layer 2 packets is set.
Run:
ipv4 field [ dip | l4-dport | l4-sport | protocol | sip | sport | vlan ] *
The load balancing mode of IPv4 packets is set.
Run:
ipv6 field [ dip | l4-dport | l4-sport | protocol | sip | sport | vlan ] *
The load balancing mode of IPv6 packets is set.
Run:
mpls field [ 2nd-label | dip | sip | sport | top-label | vlan ] *
The load balancing mode of MPLS packets is set.
Run:
quit
Return to the system view.
Run:
interface eth-trunk trunk-id
The Eth-Trunk interface view is displayed.
Run:
load-balance enhanced profile profile-name
The load balancing profile is applied.


NOTE:
The preceding load balancing modes apply only to known unicast traffic. To configure the load balancing mode for unknown unicast traffic, run the unknown-unicast load-balance { dmac | smac | smacxordmac | enhanced }command in the system view. Only the S5300EI, LS-S5328C-EI-24S   , and S5300HI support load balancing configuration for unknown unicast traffic.